HJM 810 Instrucciones De Uso página 18

CAUTION: Only operate the radiator in normal upright position with
Castor Wheel Assemblies attached to the bottom of the unit (wheels
on the bottom, controls on the top), any other position could create
a hazardous situation
OPERATE
1. Place the product in an upright position on a flat, steady, stable, heat-
resistant surface. Make sure there is nothing flammable or heat
sensitive within 1 meter (40 inches). Operating the product in any other
position could cause a hazard.
2. Insert the plug into a suitable wall outlet after turning the thermostat
knob counter-clockwise to the minimum position and setting the power
switches to "O" OFF. The heater is suitable for operation on an A.C.
power supply having the same voltage as that show on it's rating label.
3. Press the power switches knobs to either "I" (Low heating) or "II" (High
heating).
4. Turn the thermostat knob clockwise to maximum position. When the
temperature rises to with a comfortable level, slowly turn thermostat
counter-clockwise until the radiator turns off. To adjust the room
temperature turn the thermostat clockwise to raise the temperature, or
counter-clockwise to lower it. Your unit will be automatically set an on-
and-off cycle to maintain the current room temperature according to
thermostat setting. (Note: It normally requires approx. 15 minutes to
reach the operating temperature.)
5. To turn off the heater, turn the thermostat knob counter-clockwise to
"O" OFF. Press the power switches knobs to "0".
6. Unplug the product from the electrical outlet when it is left unattended
or is not in use.
+
- 17 -