ISC RP048 Instrucciones Generales De Uso página 10

EN English
[A] Nomenclature
1. Locking Mechanism
2. Body Plate (Aluminium/Steel)
3. Product Information Plate
4. Working Load Limit
5. Rope Diameter Range
6. Minimum Breaking Strength
7. Model Variant
8. Serial Number & CE Mark
[B] Care and Maintenance
[C] Use
Ideally, the device should be used when perpendicular to the stem.
1. Maximum Rope Diameter stated on product, ranging from 13mm – 19mm
2. Ensure both plates are closed and locked into place using the spring-loaded locking
axle or the screw mechanism
3. Where necessary, ensure the spring-loaded locking axle pin is secure in its secure
slot. Similarly, ensure the screw is fully locked for use.
4. Two lines are connected to the device – the Topping Strop (top) and the Working
Line (bottom)
[D] Misuse
The product is meant for use as part of a rigging system, primarily for the arborist
industry. It is NOT designed to be used for Live Loads
1. Do not use the device while it rests over protrusions from the tree, or at an angle
2. Ensure the spring-loaded locking axle pin is secure in its slot
3. Do not overload the working line as damage can be caused leading to an unsafe
device
4. Ensure that the spring-loaded axle or screw mechanism faces away from the tree
when in use
[E] Plate Operation
1. Free the plate by unscrewing the locking axle or screw mechanism
2. Once removed, the plate is able to revolve in either direction to ease the loading of
the lines
3. Once loaded, return the plate to its original position and replace the locking axle
or screw
4. Ensure the plate is properly locked back into place before use
[F] Pre-use Check
1. Check the body and moving mechanisms for any damage prior to use
2. Check for ease of movement with the plate and locking axle or screw
[G] Locking Mechanism
1. Locate Spring-loaded locking axle or screw atop the device
2. Push and twist locking axle or screw mechanism to release its grip
3. Free the locking axle or screw from opposing plate and revolve plate for access
4. Re-lock the pulley by re-aligning the locking axle or screw, push and turn to ensure
a secure lock
10
RP0XX Rigging Pulley Series: Issue B - Sep 2020