Publicidad
Step 4
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten two EXTENSION RAILS (35MA) to a LOWER END (C2 and D2). Use four
å
GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
å
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL out to fi nd
the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Repeat this step for the remaining LOWER ENDS (C2 and D2).
å
Push the black lever in and pull the SLIDE from the RAIL.
Open end
Finished edge
www.sauder.com/services
35MC
3
2
1
D2
x 2
35MA
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Finished edge
3
C2
424127
Remember:
Righty tighty.
Lefty loosey.
3S
Open end
1
2
x 2
Page 9
Publicidad
