Publicidad
Step 17
1
D28
R2
Groove
Insert the LARGE DRAWER SIDES (D28 and D29)
å
at an angle into the slot at each end of the LARGE
DRAWER FRONT (R2).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Fasten the LARGE DRAWER BACK (D151) to the LARGE DRAWER SIDES (D28
å
and D29). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D954) inserts into the groove of the
å
LARGE DRAWER BACK (D151).
Repeat this step for the other drawers.
å
Page 22
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D29
D151
D28
D29
D954
VIEW THE T-LOCK BOX VIDEO
2
D28
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D954) into the grooves in
å
the LARGE DRAWER SIDES (D28 and D29) and LARGE
DRAWER FRONT (R2).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(16 used in this step)
424127
With the palm of
your hand, tap the
DRAWER BOTTOM
down into the groove.
U n fi
n i s h
s u r
e d
f a c
e
D954
D29
R2
30S
www.sauder.com/services
Publicidad
