Sauder 409090 Manual De Instrucciones página 7

4 4
R
NAIL
(48 used in this step)
Position one of the BACKS (G) over the upper portion of your unit.
Make equal margins along all four edges of the BACK (G). Push on opposite corners of your unit if needed to make it "square".
Fasten this BACK (G) to the upper portion of your unit using the NAILS (R). The NAILS should be approximately 5" apart, 1-1/2"
from the corners, and 1/4" in from the edges.
Fasten the remaining BACK (G) to the lower portion of your unit using the NAILS (R).
IMPORTANT: The NAILS along the bottom edge of the lower BACK should be 5/8" from the edge of the BACK. Cut out and use the
"spacer" on the right side of this page for the correct nailing location.
409090
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Fasten the upper
BACK (G) fi rst.
G
The lower BACK will overlap the
upper BACK and must be even with
the top suface of the SHELF (F).
5/8" spacer
www.sauder.com/services
G
F
approximately 5"
1-1/2"
5/8"
Cut out this
rectangle to use
as a spacer.
Page 7