Troubleshooting - Lanaform Pure Manual De Instrucciones

deposited on the transducer (white ceramic ring producing ultrasounds (g)), this will prevent the "PURE" essential oils humidifier
and diffuser from working properly.
EN
Maintenance:
• We recommend:
1) using distilled or demineralised water each time it is used.
2) cleaning the reservoir every 2 days and cleaning the transducer every week.
3) changing the water in the reservoir every 2 days, or every day if you are using essential oils.
4) cleaning the device (see explanations below) and making sure that all its parts are completely dry when it is not in use.
• To clean the transducer (white ceramic ring (g)):
1) put 2 to 5 drops of vinegar on its surface and leave them there for 2 to 5 minutes.
2) brush the foam off the surface with a soft brush. Do not use a hard tool to scrape the surface.
3) Rinse the reservoir of the base in clean water.
4) Do not use soap, solvent or spray cleaner to clean the transducer.
• To clean the water basin:
1) Clean the basin with water using a soft cloth and vinegar if there is foam or limescale deposits on the inside.
2) Rinse the basin in clean water.
• To clean the cold mist emission nozzles of the device:
1) Clean these with a brush or damp cloth.
2) Rinse the nozzles in clean water.
Storage:
Having cleaned and dried the device, store it in a dry, cool place out of the reach of children.

TROUBLESHOOTING

In the event of a malfunction, under normal conditions of use, please refer to the following chart:
Effects
No steam, no light showing
8
Possible causes
If there is no light.
The water level in the reservoir is too
low.
Water is leaking from the reservoir.
The temperature of the unit is too low.
Solutions
Check that the device is connected and
no breakdown has occurred in that area.
Add water to the reservoir.
Check that the reservoir is in the right
position.
Place the unit in a room at ambient
temperature for half an hour prior to
use.