Lanaform Pure Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
Effects
Mist has an unusual smell
Low intensity
ADVICE REGARDING THE DISPOSAL OF WASTE
• All the packaging is composed of materials that pose no hazard for the environment and which can be disposed of at your local
sorting centre to be used as secondary raw materials. The cardboard may be disposed of in a paper recycling bin. The packaging
film must be taken to your local sorting and recycling centre.
• When you have finished using the device, please dispose of it in an environmentally friendly way and in accordance with the law.
LIMITED WARRANTY
LANAFORM® guarantees this product against any material or manufacturing defect for a period of two years from the date of
purchase, except in the circumstances described below.
The LANAFORM® guarantee does not cover damage caused as a result of normal wear to this product. In addition, the guarantee
covering this LANAFORM® product does not cover damage caused by abusive or inappropriate or incorrect use, accidents, the
use of unauthorized accessories, changes made to the product or any other circumstance, of whatever sort, that is outside
LANAFORM®'s control.
LANAFORM® may not be held liable for any type of circumstantial, indirect or specific damage.
All implicit guarantees relating to the suitability of the product are limited to a period of two years from the initial date of
purchase as long as a copy of the proof of purchase can be supplied.
On receipt, LANAFORM® will repair or replace your appliance at its discretion and will return it to you. The guarantee is only valid
through LANAFORM®'s Service Centre®. Any attempt to maintain this product by a person other than LANAFORM®'s Service Centre
will render this guarantee void.
Possible causes
The water has been standing in the
reservoir too long.
Too much/little water in the reservoir.
Sediment on the transducer.
The water is too cold.
The water is not clean.
Solutions
Clean the reservoir and pour fresh water
into it.
Empty the water out of the reservoir or
add water to it.
Clean the transducer.
Use water that is at room temperature.
Clean the reservoir and pour fresh water
into it.
EN
9

Publicidad

Tabla de contenido
loading

Tabla de contenido