Publicidad
Idiomas disponibles
Idiomas disponibles
EN
FR NL ES DE IT RU PL HR SL HU AR SV CS BG SK
Introduction
EN
Thank you for choosing Dolce by LANAFORM.
Providing real foot care, this Dolce pedicure
device will make your feet naturally soft. Ideal for
damaged, dry and rough feet, this exfoliating care
has been designed to smooth the skin of your feet
and heels. Thanks to its rotating abrasive disk, dead
skin on your feet will be easily eliminated.
PLEASE READ ALL THE INSTRUCTIONS BEFORE
USING YOUR DEVICE, ESPECIALLY THIS BASIC
SAFETY INFORMATION :
•
This device is not intended for use by people,
including children, with limited physical, sensory
or mental abilities, or by people lacking experience
or knowledge, unless they have been supervised or
instructed beforehand on how to use the device
by someone responsible for their safety. Children
should be supervised to ensure that they do not
play with the device.
•
Only use this device according to the instructions
given in this manual.
•
Check that your mains voltage is the same as that
of your device.
•
Keep the device away from heat sources such as
stoves, radiators, etc.
•
Do not leave the device in direct sunlight.
•
Do not connect or disconnect the plug or elec-
trical transformer of the device with wet hands.
•
If the power cable is damaged, it must be replaced
by a similar cord available from the supplier or the
latter's after-sales department.
•
Unplug the device before cleaning it.
•
Do not wash the entire unit with water and do not
immerse it in water. Consult the cleaning instruc-
tions in this manual.
•
Unplug a device that has fallen into water imme-
diately before retrieving it.
•
An electrical device should never remain
connected unsupervised. Disconnect it when you
are not using it.
•
Keep the power cable away from hot surfaces.
•
Never use this device in a room where aerosol
products (sprays) are used or in a room where
oxygen is being administered.
6
/ 32
LANAFORM "Dolce"
•
Do not use this device under a cover or under a
cushion. Excessive heat can cause fire, electrocu-
tion or injury.
•
Never use this device in a room whose tempera-
ture exceeds 40°C.
•
If the device is placed in a room where the tem-
perature is low, you are advised to wait for several
minutes before using the device in a warmer envi-
ronment. Indeed, drops of water may appear due
to condensation, in which case your device may
not work properly.
•
Do not put items of clothing or towels under or
on top of the device.
•
This device is designed for domestic use only.
•
If you are concerned about your health or are
taking medical treatment, consult a doctor before
using this device.
•
If you experience any pain when using this device,
stop using it immediately and consult your doctor.
•
Do not use this device for more than 30 minutes at
a time. Wait for one hour between each use.
•
Never use this device on a body part that is
swollen or inflamed or if you have a skin rash.
•
Do not use this equipment without consulting
your doctor in the following cases: if you are
pregnant or breast-feeding, if you have diabetes,
if your skin has tattoos or moles, if you have skin
cancer, if you have unusual skin discolouration, if
you take medicine or if you have a foot problem
such as nail fungus or over-sensitive skin. If you
are unsure, consult your doctor before using Dolce.
COMPONENTS OF THE DEVICE (SEE ILLUSTRATION
A
AT THE BEGINNING OF THESE INSTRUCTIONS) :
1
Main body
2
Protective ring
3
Cover
4
Receptacle for callused skin
5
Abrasive disk
6
Mains adaptor
7
Cleaning brush
INSTRUCTIONS FOR USE (SEE ILLUSTRATION
AT THE BEGINNING OF THESE INSTRUCTIONS) :
HOW TO USE
For an optimum result, soak your feet in warm
water for 15 minutes and dry them before using
Dolce. Rinse them to finish the treatment and mois-
turise them with a nourishing cream.
1
Open the cover. (a)
2
Connect the adaptor to the electric socket
and connect the other side to the socket on the
main body.
3
Put the lever in position 1. (b)
4
Take the main body and apply it onto your feet
using circular movements across your calluses to
remove dead skin. Do not stay in the same place
but rather move the device across a large surface
area of skin so as to not irritate it.
5
If you have thick calluses, you can put the lever
in position 2. (b)
6
Keep the upper part of the protective ring aimed
at your face and adjust the angle of the main body's
nozzle to keep residues from escaping towards
your face.
7
After use, put the lever in off position and unplug
the adaptor from the electric socket and device.
DISMANTLING AND ASSEMBLY
1
Turn the protective ring clockwise to separate it
from the main body. (c & d)
2
Lift the abrasive disk vertically to separate it from
the receptacle for callused skin. (e)
3
Vertically remove the receptacle to separate it
from the main body. (f)
4
Empty the receptacle of callused skin and use the
cleaning brush to finish. (g)
5
To re-assemble the device, first connect the
receptacle to the body of the device, verifying the
direction of the magnet. (h)
6
Place the abrasive disk on the receptacle, making
sure to properly secure it. (i)
7
Align the circular bulge of the main body with
that of the safety ring and then turn the ring coun-
ter-clockwise. (j &k)
8
Put the cover back on if you are not using the
device. (l)
B
Publicidad
