Proper Use - Würth 0772 122 42 Traducción Del Manual De Instrucciones De Servicio Original

Ocultar thumbs Ver también para 0772 122 42:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24

Proper use

The device is to be used for starting up vehicles with
an on-board voltage of 12 V or 24 V if the start-up
capacity of the vehicle batteries is insufficient. In
addition it can be used to replace defective on-
board 12 V and 24 V batteries in order to start up
the engine!
Any other use is considered improper use.
The user is liable for damage resulting
from improper use.
Operation (fig. I)
Connection and taking into service
Note
Charge the device for 24 hours before
using it for the first time!
Caution
Reverse battery protection is only
active when the battery voltage is
greater than 4 V.
Make sure the device is switched off.
First connect the cables with the red booster
cable clamp to the positive pole of the battery.
Connect the cable with the black booster cable
clamp to the negative pole of the battery.
When connecting the booster cable clamps
ensure good contact and secure fit.
Switch on the device.
10
LED indicator
Indicator
Status
Reverse connec-
Disconnect the booster cable
tion indicator [11]
clamps, interrupt start-up
lights red
procedure
Reverse connection
Booster cable is not connected
indicator [11] is
Vehicle battery voltage is less
not lit
than 4 V or vehicle battery is
missing altogether.
Reverse connec-
Start-up procedure, press the
tion indicator [11]
ON button [1]
lights green
Charge level
Start-up procedure
LEDs [2] and [10]
light green
Charge level
Start-up procedure with
LEDs [2] and [10]
reduced start-up capacity
light orange
Charge level
Battery voltage too low
LEDs [2] and [10]
light orange
Automatic jump start
Use this function for start-up with the vehicle batter-
ies in place. It helps to make best use of the extreme
start-up capacity of the battery booster kit.
Check LED [8]; if LED is not lit, automatic start is
not possible.
Press the AUT button [9].
3 LED [8] lights green; device is ready for opera-
tion.
3 The engine can be started; the start-up voltage is
then switched on automatically.
3 If the clamps are energised, the LED [4] or [7]
lights red!
Note
If you are not sure about the automatic
voltage selection, check the on-board
voltage and choose the voltage
manually. This can be done anytime
by pressing the buttons 12 V [5] or
24 V [6].
3 After 6 seconds the start-up procedure is auto-
matically stopped.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

0772 122 44

Tabla de contenido