Cleaning And Maintenance; Environmental Protection; Accessories And Spare Parts - Würth 0772 122 42 Traducción Del Manual De Instrucciones De Servicio Original

Malfunction
Reverse connection LED [11] is not lit.
Reverse connection LED [11] lights red.
LEDs [2] and [10] light red.
LED [4] or [7] lights red.
Device switches off after start-up attempt.

Cleaning and maintenance

Important!
The device may only be cleaned with
the mains plug disconnected.

Environmental protection

Do not dispose of the device with
domestic waste. Have the device
disposed of by an authorised waste
management company or your
municipal waste management
organisation. Adhere to the applica-
ble regulations. In case of doubt
contact your waste management organisation.
Recycle all packaging material in an environmen-
tally friendly manner.
Batteries:
Do not dispose of batteries with domestic waste,
do not expose to fire or water. Collect and recy-
cle batteries or dispose of with due care for the
environment.
12
Notes on troubleshooting
Cause
– Booster cable clamps are not connected.
– Vehicle battery voltage is less than 4 V or vehicle bat-
tery is missing altogether.
– Short circuit in a vehicle battery cell
– Booster cable clamps are connected incorrectly.
– Charge of booster kit too low; charging not pos-
sible.
– No voltage on booster cable clamps; start-up
procedure not possible.
– Charge level of booster kit battery too low.
– Fuse integrated into the device defective.
– Vehicle causes a short circuit; remove defective
vehicle battery
For this Würth appliance the following guarantees
apply:
– Battery booster kit and charger: 24 months
– Battery in battery booster kit: 12 months
– Cable clamps and fuses are excluded as they are
The warranty period starts with the date of purchase
(verified by invoice or delivery document).
Faults covered by warranty shall be eliminated by
replacement or repair. Damage caused by improper
operation is not covered by warranty.
Claims under warranty shall only be considered if
the device is returned fully assembled to a Würth
agency, your Würth sales representative or a
customer service workshop for electrical equipment
authorised by Würth. Technical changes reserved.
We accept no liability for printing errors.
In the unlikely event of a failure or defect, have the
device repaired by a Würth masterService work-
shop. In all your queries and spare part orders,
always quote the product number (see type plate) of
your device.
Warranty
wear parts.

Accessories and spare parts