Würth 0772 122 42 Traducción Del Manual De Instrucciones De Servicio Original página 11

Note
After a waiting time of approx. 10 sec-
onds the start-up procedure can be re-
peated up to 5 times. Then the vehicle
must be checked and the battery of the
device must be charged.
Engine is running
Switch off the device after approx. 2 minutes.
■
Remove booster cable clamps.
■
Switching on 12 V or 24 V voltage
manually
Check LED [8].
■
Press the MAN button [3].
■
Important
Booster cable clamps are live!
Jump start
Start engine of the vehicle.
■
Caution
Do not disconnect or switch off the de-
vice directly after start-up as otherwise
the on-board electronics and/or the
generator may be damaged!
Switch off the device after approx. 2 minutes.
■
Remove booster cable clamps.
■
Caution
If the engine is not running after 6 sec-
onds, the start-up procedure must be
interrupted immediately as otherwise
the battery booster kit and the vehicle
may be damaged.
Note
After a waiting time of approx. 10 sec-
onds the start-up procedure can be re-
peated up to 5 times. Then the vehicle
must be checked and the battery of the
device must be charged.
Note
The electronic control switches off the
voltage after approx. 45 minutes in
order to avoid unintentional discharge
of the device batteries.
Jumpstart without vehicle battery
Connect the booster cable clamps directly to the
■
vehicle's battery terminals.
Caution
Do not disconnect or switch off the de-
vice as this may damage the on-board
electronics and/or the generator!
Engine is running
Switch off the device
■
Remove booster cable clamps.
■
Charging
Charge the device for 24 hours before using it
■
for the first time.
Connect the device to the charger provided
■
after each start-up.
3 This will ensure that the device remains ready
for use.
Note
It is not a problem to have the device
connected to the charger provided
permanently.
11