BEVERAGE CENTER USE
Normal Sounds
Your new beverage center may make sounds that your old one
didn't make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
Your beverage center is designed to run more efficiently to
keep your food items at the desired temperatures and to
minimize energy usage. The high efficiency compressor and
fans may cause your beverage center to run longer than your
old one. You may also hear a pulsating or high-pitched sound
from the compressor or fans adjusting to optimize
performance.
Rattling noises may come from the flow of refrigerant or items
stored inside the beverage center.
As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your beverage center.
You may hear water running into the drain pan when the
beverage center is defrosting.
You may hear clicking sounds when the beverage center
starts or stops running.
Using the Controls
The control panel for the beverage center is located on the
middle separator (mullion) of the beverage center. The control
of the beverage center has no mechanical parts or buttons.
When disconnected, the control panel displays nothing and
may be difficult to locate.
Turning Control On/Off
The first time that the beverage center is plugged in, the
control will be in Cool Off mode. Cool On and Cool Off will
be the only options that display.
6
Press COOL ON for 3 seconds to turn on the beverage
center. All menus and recommended temperature settings
will be displayed.
The left temperature and preset touch pads control the
temperature of the upper compartment.
The right temperature and preset touch pads control the
temperature of the lower compartment.
Viewing Celsius Temperatures
Press the F/C touch pad to toggle between displaying the
temperature in degrees Fahrenheit and degrees Celsius.
The corresponding indicator will illuminate.
A. F/C touch pad
Adjusting the Control
When the beverage center is turned On for the first time, the
temperature defaults to the recommended setting. There are two
adjustable temperature controls, with one for each compartment.
To adjust set point temperatures, press "+" (plus) or "-"
(minus) until the desired temperature setting is reached.
NOTE: The set point for the beverage center is 37°F (3°C) for the
upper compartment and 50°F (10°C) for the lower compartment.
The set point range for the upper compartment is 33°F to 40°F
(0°C to 4°C) and 42°F to 64°F (5°C to 17°C) for the lower
compartment
The control is set correctly when your beverages are as cold as
you like them.
NOTE: Wait at least 24 hours between adjustments for the
beverage center to acclimate. Recheck the temperatures before
making further adjustments.
Using Presets
For your convenience, your beverage center also has controls
that are preset to recommended storage temperatures for
specific beverages.
.
A