Remove And Replace Handle Medallions (Optional); Adjust The Doors; Refrigerator Use; Opening And Closing Doors - KitchenAid KRFC302ESS Instrucciones Para El Usuario

Remove and Replace Handle Medallions
(optional)
The handles for your model have red medallions on the ends.
Replacement medallions are available for purchase. See
"Accessories" to order.
1. Using a 1/8" hex key, remove the medallion from the end of
the handle.
2. Replace medallion.
3. Using the fastener removed in Step 1, attach the medallion to
the handle.
A
A. Handle medallion

Adjust the Doors

IMPORTANT:
Your refrigerator has two adjustable, front leveling screws –
■
one on each side of the refrigerator base. If your refrigerator
seems unsteady or you want the door to close easier, use the
instructions below.
Before moving the refrigerator, raise the leveling screws so the
■
front rollers are touching the floor.
1. Remove the two screws fastening the base grille to the
cabinet, and set the screws aside. Grasp the grille and pull it
toward you.
2. Raise or lower the cabinet.
Using a 1/4" hex driver, turn the leveling screw on each side
to raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the refrigerator
takes some weight off the leveling screws. This makes it easier to
turn the screws. It may take several turns of the leveling screw to
adjust the tilt of the refrigerator.
To raise, turn the leveling screw clockwise.
■
8
To lower, turn the leveling screw counterclockwise.
■
A. Leveling screw
B. Front roller
3. Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling screws clockwise. It may take several
more turns, and you should turn both screws the same
amount.
4. Replace the base grille.

REFRIGERATOR USE

Opening and Closing Doors

There are two refrigerator compartment doors. The doors can be
opened and closed either separately or together.
There is a vertically-hinged seal on the left refrigerator door.
When the left-hand refrigerator door is opened, the hinged
■
seal automatically folds inward so that it is out of the way.
When both doors are closed, the hinged seal automatically
■
forms a seal between the two doors.
A. Hinged seal
Wine Rack
(on some models)
Under one shelf, there are brackets installed to the supports (one
bracket on each support). The wine rack rests in these brackets.
To remove and replace the wine rack:
1. Remove the wine rack by lifting it up off the brackets. Press
the right-hand side of the rack inward until it is free of its
bracket. Lower the right-hand side slightly and disengage the
left-hand side from its bracket.
¹⁄₄"
A
B
A