Zipro Heat Manual De Uso página 30

EN
STEP 3.
a. Slide horizontally the long
axle (56) into its opening in the
handlebar post (4).
Put the left and right handle arm
(7L/R) on the long axle (56) with
bolts (26), flat washers (10), and
wave washers (21).
Do not tighten all the elements
yet.
b.Put the rear parts of the pedal
bases (8L/R) on the crank (20)
and fix them with bolts (26),
spring washers (18), and flat
washers (10).
Do not tighten all the elements
yet.
c. Screw the left and right
handle arm (7L/R) together with
the left and right pedal base
(8L/R) with bolts (37), flat
washers (12), and nuts (13).
Tighten all elements.
d. Install the left and right pedal
(34L/R) on the left and right pedal
base (8L/R) with hexagonal bolts
(33), flat washers (12), and
nuts(13).
NOTE! The right pedal is marked
'R' and the left pedal is marked
'L'.
STEP 4.
a. Fix the left and right handle
(6L/R) to the left and right handle
arm (7L/R) with bolts (44), curved
washers (43), and nuts (13).
b. Remove heart rate cables (49)
from the handlebar (5) through
the handlebar post (4).
Fix the handlebar (5) to the
handlebar post (4) using bolts
(53), spring washers (18), and flat
washers (12) as shown.
Install the handlebar cover (58).
30