Adding Water And Ground Coffee; Brewing Coffee Now - Mr Coffee CG Serie Manual Del Usuario

Adding Water and Ground Coffee:

1. Open the brew basket lid. For your
convenience, you can lift out the
removable filter basket.
2. Place a MR. COFFEE brand 10-12 cup
®
paper basket-style filter or a
MR. COFFEE permanent filter into the
®
removable filter basket. (Figure 2)
NOTE: If using paper filters, it is
important that the sides of the filter fit flush against the
side of the filter basket. If filter collapse occurs, dampen
the filter before placing in the filter basket and adding
ground coffee and water.
3. Add the desired amount of coffee and gently shake to
level the coffee. See the Suggested Coffee Measurement
Chart.
4. Be sure the removable filter basket is properly centered
and all the way down in the brew basket and close the
lid.
5. Fill the decanter with cold, fresh water to the desired
capacity (1 cup equals 5 ounces). For easy and accurate
filling, the water markings on the glass decanter and
on the dual water windows show the amount of water
needed to make the corresponding desired number of
cups.
6. Do not fill the reservoir past the "12 cup MAX line" or
water will flow out of the overfill hole in the back of the
coffeemaker.
7. Lift the pour through reservoir lid and pour the water
into the water reservoir. Close the lid and place the
empty decanter onto the warmer plate.
The amount of coffee brewed will always be slightly less
than the amount of water poured in the water reservoir. This is
due to the minimum absorption of water by the coffee grounds.
12
BVMC-CG12CUP_12ESM1.indd 13-14
NOTE: Make sure the decanter is fully placed on the warming
plate or the water and the grounds will overflow from the
filter basket. An overflow may cause personal injury or
damage to property.
Figure 2

bREWING COFFEE NOW

1. After completing the steps in the "Adding Water and
Ground Coffee" section and with the decanter and the
filter basket securely in place, turn the coffeemaker on.
For Programmable models: Press the ON Button to begin
the brewing cycle.
The green indicator light will turn on to signal that the
coffeemaker is brewing. When the brewing cycle is
complete the coffeemaker switches over to the warming
mode.
Your coffeemaker will keep your coffee hot for 2 hours,
then automatically shut off. Thermal units will shut off
immediatly after the brewing cycle is complete. While the
coffee is brewing, the Pause n' Serve feature allows you
to sneak a cup of coffee from the decanter. REPLACE THE
DECANTER ON THE WARMING PLATE WITHIN 30 SECONDS
TO PREVENT OVERFLOW AND POSSIBLE INJURY.
To turn the coffeemaker off, push the OFF button.
WARNING: To reduce the risk of damaging the
decanter and/or the risk of personal injury, do not
add cold water to the decanter if the decanter is
already hot. Allow the decanter to cool before using.
13
10/18/12 2:13 PM