Care & Cleaning; Service And Customer Care - Kenwood CM650 Serie Manual De Instrucciones

2 Open the filter door by pressing the
release button and insert the filter
holder.
3 Add either a permanent filter or a
paper filter. Add the coffee
(approximately 1 rounded
dessertspoon/7g per cup). Then
close the filter door.
4 Put the jug on the hotplate.
5 Plug in and switch on.
●
Model CM650 press the on/off
switch. The light will come on.
●
Model CM660 press the
auto/on/off button twice. The light
will come on.
6 CM660: to produce stronger coffee
press the strength control button.
●
During operation the strength control
indicator light will glow for
approximately 10 minutes.
7 Don't remove the jug until brewing
has finished. The hotplate will keep
your coffee hot, but the sooner you
drink it, the better it will taste.
●
Model CM660 After 2 hours,
power to the hotplate will cease and
the auto/on/off indicator light will go
out.
8 When the jug's empty, switch off by
pressing the on/off switch (CM650)
or the auto/on/off button (CM660).
Let the machine cool down before
cleaning.
●
If you haven't used the machine for
a while, run one lot of water through
it (without coffee) to clean it out. Fill
the tank to the top cup mark when
you do this.
●
Never put the jug in the microwave.
to use the automatic timer
(model CM660 only)
1 Set the correct time.
2 Press the automatic timer button
and at the same time adjust the
Hour and Minute buttons to display
the time you want the coffee maker
to come into operation. Make sure
that the desired AM or PM is
selected.
3 Release the automatic timer button.
4 Press the auto/on/off button once.
The automatic timer light will glow.
●
When the set brewing time is
reached the coffee maker will
operate, the automatic timer light will
go out and the auto/on/off light will
come on.
care & cleaning
●
Always switch off and unplug before
cleaning.
●
Never put the machine in water or let
the cord or plug get wet.
jug, lid, filter holder,
permanent filter
●
Wash, then dry.
body, filter door
●
Wipe with a damp cloth, then dry.
Don't use abrasives - they'll scratch
the plastic.
descaling
You'll know when limescale has built
up because your coffee will take
longer to come through. When this
happens it's time to descale.
to descale
1 Buy a suitable descaler.
2 Descale the machine.
3 After descaling, run several lots of
water through the machine to clean
it out. Fill the tank to the top cup
mark when you do this.
4 Wash the parts.
service and customer
care
●
If the cord is damaged it must, for
safety reasons, be replaced by
Kenwood or an authorised Kenwood
repairer.
If you need help with:
●
using your machine or
●
servicing, spare parts or repairs
contact the shop where you bought
your machine.
3