Care & Cleaning; Service And Customer Care - Kenwood CM470 Serie Manual De Instrucciones

3 To set the clock press the on/off
button or wait 1 minute for it to
automatically set.
To re-adjust the clock at any time,
●
press and hold the clock button for
5 seconds and adjust the clock as
above.
Note – the backlight of the display
will automatically turn off after 1
minute.
to program automatic brew
1 Set the clock to the correct time (see
'to set the clock').
2 Press the program button, the clock
symbol and the display will flash.
3 Press the clock button until the
desired brewing time is displayed
(follow procedure in 'to set the
clock').
4 Press the on/off button to confirm
the automatic time selected. (The
display panel and the on/off indicator
light will flash).
5 Press the program button to return
to the current time of day (the on/off
button will continue to flash). The
brewing cycle will begin once the set
time is reached and the on/off
button will stop flashing.
●
If you want to check the automatic
time selected, press the program
button.
●
To override the automatic brewing
operation press the on/off button
and the coffee maker will start
immediately. Press the button again
to switch off.
care & cleaning
●
Always switch off, unplug and allow
to cool before cleaning.
●
Never put the machine in water or let
the cord or plug get wet.
●
Don't wash parts in the dishwasher.
water filter
●
Change and discard the water filter
after 70 brewing operations or within
a calender month whichever is
sooner.
carafe, lid, permanent filter,
filter holder, water filter
holder
●
Wash, then dry.
body
●
Wipe with a damp cloth, then dry.
Don't use abrasives - they'll scratch
the plastic and metal surfaces.
descaling
With use, the display will indicate
when the coffee maker requires
descaling. A series of solid lines will
gradually appear and when 4 appear
in the display and flash
coffee maker has completed 100
cycles or more and requires
descaling (see 'to descale').
important
When descaling always remove the
water filter and water filter holder
first.
to descale
1 Buy a suitable descaler.
2 Descale the machine.
3 After descaling, run several lots of
water through the machine to clean
it out. Fill the tank to the top cup
mark when you do this.
4 Wash the parts.
5 To reset the descale counter to zero,
press the clock and program button
at the same time for 2 seconds.
service and customer
care
●
If the cord is damaged it must, for
safety reasons, be replaced by
Kenwood or an authorised Kenwood
repairer.
If you need help with:
●
using your machine or
●
servicing, spare parts or repairs
Contact the shop where you bought
your machine.
4
, the