Using The Stove; Power On; Modifying The Parameters; Power Off - Palazzetti EASYTOUCH Uso Y Funciones

3

Using the stove

3.1 Power on

Before each ignition, make sure that the burn pot is completely empty and correctly
positioned in its seat.
To turn on the stove keep the key
The flame icon will start to flash, during the ignition phase until it remains fixed when the
stove is on.
Automatic ignition: the stove is equipped with an automatic device that allows pellet
ignition without the use of other traditional ignitors.
Avoid manually turning on the stove if the automatic ignition system is compromised.
During the first ignition of the stove, unpleasant odours or fumes may be generated due
to the evaporation or drying of certain materials used. This phenomenon will gradually
disappear.
During the first ignitions, it is advisable to keep the premises well ventilated.

3.2 Modifying the parameters

It is possible to change the operating parameters of the stove according to what has already
been stated.
The set values will be maintained until the next change, even with the stove off or
disconnected from the power supply.

3.3 Power off

To turn off the stove keep the key
To switch on again, it is advisable to wait for the stove to cool completely.
It is advisable to turn off the stove strictly following the above and always avoid doing so
by removing the power supply.
After ten hours of continuous operation, the stove will perform an automatic shutdown
and restart in order to guarantee optimal cleaning of the burn pot.
pressed for a few seconds.
pressed for a few seconds; the flame icon will go out.
004778190 - 08/04/2021 27