Descargar Imprimir esta página

Mopar 82212166 Manual De Instrucciones página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

18. Remove the white/orange wire (1) from cavity 11.
19. Carefully cut 3­4 inches of the vehicle harness tape
wrap away and pull the white/orange wire away from
the harness.
20. Measure approximately 4 inches from the pin of the
white/orange wire and mark accordingly for splice lo­
cation.
21. Prepare to crimp/splice the white rear fog lamp relay
wire to the white/orange wire of the front fog lamp
driver circuit as follows:
a. Remove 13 mm (0.5 in.) of insulation from each
wire that needs to be spliced.
b. Place a piece of adhesive lined heat shrink tubing
(2) on one side of the wire. Make sure the tubing
will be long enough to cover and seal the entire
repair area.
c. Place the strands of wire overlapping each other
inside of the splice clip (1).
Feb 18, 2011
7
K6860984

Publicidad

loading