Quick Instructions For Use Of The Sauna Heater; Check Before Taking A Sauna Bath; Operation Of The Sauna Heater Controls; Information For Users - Helo RING WALL D Instalación Y Manual De Uso

Installation and User Manual

1. Quick instructions for use of the sauna heater

1.1 Check before taking a sauna bath

1. The sauna room is suitable for taking a sauna bath.
2. The door and the window are closed.
3. The sauna heater is topped with stones that comply with the manufacturer's recommendations, the
heating elements are covered with stones, and the stones are piled sparsely.
NOTE! Ceramic rocks are not allowed.
A pleasant, smooth sauna bath temperature is about 70 °C degrees.
Rearrange the sauna stones at least once a year and replace any weathered stones. This enhances air circu-
lation between the stones, which extends the useful life of the heating elements.
If you encounter any problems, please contact the manufacturer's warranty service shop.
For additional information about enjoying a sauna bath, please visit our website at www.helo.fi

1.2 Operation of the sauna heater controls

The main switch is on the side of the contactor case. The type plate shows the position of the switch. ( 0 I )
For contactor case and control panel use, refer to the specific operating manuals.

2. Information for users

This appliance may not be used by children aged less than eight years, by persons with reduced physical,
sensory or mental capabilities, or by persons lacking experience and knowledge regarding its operation only if
such have been given instructions on the safe use of the device and the risks involved. Children must not be
allowed to play with the appliance or to clean and service it without supervision. (7.12 EN 60335-1:2012)

2.1 Sauna room

The walls and ceiling of a sauna room should be thermally well insulated. All surfaces that store heat, such as
tiled and plastered surfaces must be insulated. It is recommended to use wooden panel cladding inside the
sauna room. If there are heat storage elements in the sauna room, such as decorative stone, glass etc., note
that these elements may extend the pre-heating period even though the sauna room is otherwise well insulat-
ed (see page 6, section 2.6. Preparing for sauna heater installation).

2.2 Heating the sauna

Before turning the sauna heater on, make sure the sauna room is suitable for taking a sauna bath. When
heated for the first time, the sauna heater may emit some odour. If you detect any odour while the sauna
heater warms up, disconnect the sauna heater briefly, and air the room. Then turn the sauna heater back on.
The sauna heater is turned on by twisting the timer knob, and the temperature is adjusted from the thermostat
knob.
You should turn the sauna heater on roughly an hour before you plan to take a sauna bath, so that the stones
have time to heat up properly and the air warms up evenly in the sauna room.
Do not put any objects on the sauna heater. Do not dry clothes on the sauna heater or anywhere in its
vicinity.
Ring Wall D
3