Use Instructions; Power On/Off; Dab Radio - Denver DAB-47 Manual De Instrucciones

Use instructions

Power On/off

1.
Connect the power adaptor to the DC IN jack at the back of the unit, and connect the other end of
the power adaptor to a mains outlet.
2.
Press the button to turn ON the unit.
3.
Press the DAB/FM button to toggle between DAB and FM modes.
4.
To switch to standby mode, press the
Battery power (optional).
Note: Before installing the batteries (not included), ensure that the unit is unplugged from the mains
outlet.
Open the battery compartment, and insert 4 AA batteries (1.5 V, also known as LR-6) with correct
polarities (+/-) as indicated, then replace the battery compartment until it clicks into place.

DAB radio

Store DAB radio stations automatically
1. Press the DAB/FM button to select DAB mode.
2. When switching to DAB mode for the first time, the unit performs a full scan and store all the available
DAB radio stations.
3. Once the scanning finishes, the unit broadcasts the first alphanumerically found station. Press the TUNING
▲/▼ button to select a DAB radio station, and press the SELECT button to confirm your selection.
Perform full DAB scan manually
To perform a full scan manually, in DAB mode, press and hold the MENU button to access the menu options,
then press the TUNING ▲/▼ button to select "Full Scan", and then press the SELECT button to start a full
scan.
Prune DAB radio stations
You can remove the DAB stations from the station list that cannot be received in your area.
A DAB radio station which cannot be received in your area is listed with a '?' mark before a station name.
In DAB mode, press and hold the MENU button to access the menu options, then press the TUNING
1.
▲/▼ button to select "PRUNE", and then press the SELECT button to confirm.
Then "Prune? Yes <No>" is displayed. Press
2.
SELECT button to remove the current radio station from the station list.
button again.
the TUNING ▲/▼ button
3
to select "<Yes>", then
press the