Service And Repairs - Stanley Fatmax FMHT1-77416 Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

Using the Laser with Accessories

WARNING:

Since accessories other than those offered by

Stanley have not been tested with this laser, use of

such accessories with this laser could be hazardous.

Only use Stanley accessories that are recommended for use

with this model. Accessories that may be suitable for one laser

may create a risk of injury when used with another laser.

The bottom of the laser is equipped with 1/4-20 and 5/8-11

female threads (Figure

) to accommodate current or future

Stanley accessories. Only use Stanley accessories specified

for use with this laser. Follow the directions included with the

accessory.

Recommended accessories for use with this laser are available

at extra cost from your local dealer or authorized service center.

If you need assistance locating any accessory, please contact

your nearest Stanley service center or visit our website:

http://www.2helpU.com.

Maintenance

• When the laser is not in use, clean the exterior parts with

a damp cloth, wipe the laser with a soft dry cloth to make

sure it is dry, and then store the laser in the kit box provided.

• Although the laser exterior is solvent resistant, NEVER use

solvents to clean the laser.

• Do not store the laser at temperatures below -20 ˚C (-5 ˚F) or

above 60 ˚C (140 ˚F).

• To maintain the accuracy of your work, check the laser often

to make sure it is properly calibrated.

Calibration checks and other maintenance repairs may be

performed by Stanley service centers.

Troubleshooting

The Laser Does Not Turn On

• Check the AA batteries to make sure:

• Each battery is installed correctly, according to (+) and (–)

listed inside the battery compartment.

• The battery contacts are clean and free of rust or

corrosion.

• The batteries are new, high-quality, name brand batteries

to reduce the chance of battery leakage.

• Make sure the AA batteries are in proper working condition. If

in doubt, try installing new batteries.

• When using rechargeable batteries, make sure the batteries

are fully charged.

• Be sure to keep the laser dry.

• If the laser unit is heated above 50 ˚C (120 ˚F), the unit will

not turn ON. If the laser has been stored in extremely hot

temperatures, allow it to cool. The laser level will not be

damaged by using the Power/Transport Lock switch before

cooling to its proper operating temperature.

The Laser Beams Flash

The lasers are designed to self-level up to an average of

4° in all directions. If the laser is tilted so much that the

internal mechanism cannot level itself, the laser beams will

flash indicating that the tilt range has been exceeded. THE

FLASHING BEAMS CREATED BY THE LASER ARE NOT

LEVEL OR PLUMB AND SHOULD NOT BE USED FOR

DETERMINING OR MARKING LEVEL OR PLUMB. Try

repositioning the laser on a more level surface.

The Laser Beams Will Not Stop Moving

The laser is a precision instrument. Therefore, if it is not

positioned on a stable (and motionless) surface, the laser will

continue to try to find level. If the beam will not stop moving, try

placing the laser on a more stable surface. Also, try to make

sure that the surface is relatively flat and level, so that the laser

is stable.