Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Keypad, Modes, and LED
Keypad /Switch
Power On/Pendulum lock off /Self-leveling On
Power Off/ Pendulum lock on /Self-leveling Off
Modes
(See figure
D
Laser Beam Available Modes
•
Horizontal & Plumb, Dot Beams Only
Unlocked /Self-Leveling (See figures
•
Power is ON, pendulum lock is OFF
within self-leveling range.
Locked /Self-Leveling (See figures
•
Power is OFF , pendulum lock is ON.
LEDs
(See figure
)
A
Out of level LED - Solid RED
•
Unit is out of level
QuickLink ™ Bracket Overview
Figure F -QuickLink ™ Bracket
10. T-nut to mate with slots on Laser Unit.
11. Jaw Tightening Knob.
12. Bracket Tightening Knob .
13. Hang holes for screw mounting. (34 mm apart)
14. 1/4-20" threaded mount.
15. Adjustable Jaw
Bracket Applications
• The QuickLink bracket can be mounted in various
positions by clamping the jaws to round or flat objects
such as a tripod pole, door or bench and tightening the
knobs. ( See figure
F
STHT77342
(See figure
)
C
)
)
C
and laser unit is
)
C
.
: #11 & #12)
• The QuickLink bracket can be mounted on a vertical
surface using the hang holes provided. (See figure
#13)
F
•
• The QuickLink bracket can be attached to the bottom
of the laser unit using the 1/4-20" threaded mount
(Figure
#14 and figure
F
slot connection.
Batteries and Power
Battery Installation / Removal
(See figure
)
B
Laser Tool
• Turn laser tool to bottom. Open battery compartment
cover by pressing and sliding out.
• Install / Remove batteries. Orient batteries correctly
when placing into laser tool.
• Close and lock battery compartment cover by sliding in
until securely closed.
WARNING:
• Pay close attention to the battery holder's (+)
and (-) markings for proper battery insertion.
Batteries must be of same type and capacity.
Do not use a combination of batteries with
different capacities remaining.
#1) or the t-nut and
A
9
Publicidad
Tabla de contenido
