Troubleshooting; Service And Repairs - Stanley STHT77502-1 Manual Del Usuario

Troubleshooting

The Laser Does Not Turn On
• Check the AA batteries to make sure:
• Each battery is installed correctly, according
to (+) and (–) listed inside the battery
compartment.
• The battery contacts are clean and free of rust
or corrosion.
• The batteries are new, high-quality, name
brand batteries to reduce the chance of battery
leakage.
• Make sure the AA batteries are in proper working
condition. If in doubt, try installing new batteries.
• When using rechargeable batteries, make sure the
batteries are fully charged.
• Be sure to keep the laser dry.
• If the laser unit is heated above 120 ˚F (50 ˚C), the
unit will not turn ON. If the laser has been stored
in extremely hot temperatures, allow it to cool. The
laser level will not be damaged by using the Power/
Transport Lock switch before cooling to its proper
operating temperature.
The Laser Beams Flash
When in self-leveling mode, the lasers are designed
to self-level up to an average of 4° in all directions. If
the laser is tilted so much that the internal mechanism
cannot level itself (or the laser is not level when in
manual mode), the laser beams will flash indicating
that the tilt range has been exceeded.
THE FLASHING BEAMS CREATED BY THE LASER
ARE NOT LEVEL OR PLUMB AND SHOULD NOT BE
USED FOR DETERMINING OR MARKING LEVEL
OR PLUMB. Try repositioning the laser on a more
level surface.
Laser Beams Will Not Stop Moving
The laser is a precision instrument. Therefore, if it is
not positioned on a stable (and motionless) surface,
the laser will continue to try to find level. If the beam
will not stop moving, try placing the laser on a more
stable surface. Also, try to make sure that the surface
is relatively flat and level, so that the laser is stable.

Service and Repairs

Note: Disassembling the laser level will void all
warranties on the product.
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
authorized service centers. Service or maintenance
performed by unqualified personnel may result in a risk
of injury. To locate your nearest STANLEY service
center, go to http://www.STANLEY.com.
Two Year Warranty
Stanley warrants its electronic measuring
tools against deficiencies in materials and / or
workmanship for two years from date of purchase.
Deficient products will be repaired or replaced,
at Stanley's option, if sent together with proof of
purchase to:
Stanley UK Sales Limited
Gowerton Road
Brackmills, Northampton NN4 7BW
This Warranty does not cover deficiencies caused
by accidental damage, wear and tear, use other than
in accordance with the manufacturer's instructions
or repair or alteration of this product not authorised
by Stanley.
Repair or replacement under this Warranty does not
affect the expiry date of the Warranty.
To the extent permitted by law, Stanley shall
not be liable under this Warranty for indirect or
consequential loss resulting from deficiencies in
this product.
This Warranty may not be varied without the
authorisation of Stanley.
This Warranty does not affect the statutory rights of
consumer purchasers of this product.
This Warranty shall be governed by and construed in
accordance with the laws of the country sold where
in and Stanley and the purchaser each irrevocably
agrees to submit to the exclusive jurisdiction of
the courts of that country over any claim or matter
arising under or in connection with this Warranty.
Calibration and care are not covered by warranty.
GB
15