Setup - Greenlee 884 Manual De Instrucciones

Setup

O
1. Place the cylinder block of the ram (A) between the
two halves of the frame unit (D).
2. Insert the cylinder block pins (C) through the frame
unit (D) and cylinder block of the ram (A). Secure the
cylinder head pins in place with the spring clips (B).
3. Select the appropriate shoe support and shoe
support pins as follows:
• For 2" and smaller bending shoes, secure the
small shoe support (G) to the ram with the small
ram pin (H). Secure the pin (H) with a spring clip
(K). Attach the shoe (J) to the small shoe support
(G) with the small shoe pin (I).
• For 2-1/2" and larger bending shoes, secure the
large shoe support (L) to the ram with the two
large support ram pins (M). Attach the shoe (J),
with counterbored holes upward, to the large shoe
support (L) with the large shoe pin (N). Secure the
pin (N) with spring clip (B).
Greenlee / A Textron Company
A
C
B
F
E
884 and 885 Hydraulic Benders
C
B
D
M
N
L
B
4. Place the pipe supports (F) into the frame, locat-
ing them in the hole positions that correspond to
the size of conduit or pipe to be bent. Insert the
pipe support pins (E) through the frame unit (D)
and through the pipe supports (F). Secure the pipe
support pins in place by turning the locking pin over
the ball.
5. Position the pipe support so that the appropriate
side of the pipe support is toward the conduit.
6. Connect the high-pressure hydraulic hose (O) to the
ram (A) and to the pump (not shown).
Note: Clean the quick-change couplers before
making the connections. Hand-tighten the couplers
completely. Do not use tools.
Follow the instructions and safety information supplied
with your hydraulic pump.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
E
F
H
I
G
J
K
J