Troubleshooting - Black and Decker GWC54PC Manual Del Usuario

Switching on and off (Fig. H)
POWERCOMMAND feature (Fig. I)

Troubleshooting

Hold the sweeper with one hand as shown in Figures H
and J and sweep from side to side with the nozzle several
inches above the ground. Slowly advance keeping the
accumulated pile of debris in front of you.
Warning! Do not point unit discharge at self or bystanders.
To switch the sweeper on, depress the on/off trigger as
shown in Figure H.
To switch the sweeper off, Release the on/off trigger as
shown in H.
The POWERCOMMAND feature allows you to optimise the
tools performance and boost the power as needed.
Switch the blower on.
To activate the "Boost" mode, press the
POWERCOMMAND button down.
To deactivate the "Boost" mode, press the
POWERCOMMAND button.
Operate in "Normal" mode for most sweeping needs.
(Longer runtime will be achieved.)
Activate "Boost" mode as needed to clear heavy or wet
debris.
Problem Possible cause
Unit will not start. Battery not installed
properly.
Battery not charged.
Battery will not charge. Battery not inserted into
charger.
Charger not plugged in.
Surrounding air
temperature too hot or
too cold.
u
u
u
u
u
u
u
u
Protecting the environment
Technical data
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions.
Input Voltage
Speed
Weight
Battery
Voltage
Capacity
Type
Charger
Input voltage
Possible solution
Current
Check battery
installation.
Approx. charge
time
Check battery
Insert battery into
charger until green
LED appears.
Plug charger into a
working outlet. Refer
to "Important Charging
Notes" for more details.
Check current at
receptacle by plugging
in a lamp or other
appliance.
Check to see if
receptacle is
connected to a light
switch which turns
power off when you
turn out the lights.
Move charger and
tool to a surrounding
air temperature of
above 40 degree F
(4.5°C) or below 105
degree F (+40.5°C).
Z
charging requirements.
MACHINERY DIRECTIVE
OUTDOOR NOISE DIRECTIVE
EC declaration of conformity
(Original instructions)
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Hand/arm weighted vibration value according to
EN 50636-2-100:
= < 6,5 m/s , uncertainty (K) = 1,5 m/s
L (sound pressure) 91 dB(A)
uncertainty (K) = 2,5 dB(A)
GWC54PC, GWC54PCB blower
GWC54PC
54
V
Km/h 160
4.4
kg
N476407
54/18v
V
DUALVOLT
1.5
Ah
LI-Ion
90642266
V 220 - 230
mA 2000mA
2.75
h
DC
DC
AC
2
PA
%
ENGLISH
.
9
GWC54PCB
54
160
3.5
Bare unit (no Battery)
Bare unit (no Charger)
2