Cosatto the ABCs judo Manual De Instrucciones página 8

Group 1 mode (9 to 18kg, approx. 9 months to 4 years old):
i/ ISOFIX option (fitted with ISOFIX low anchorage points and top-tether strap):
Loaction
Preparation
Fitting
5
7- Harness tension:
Always make sure that the harness is correctly tensioned to
ensure maximum protection for your child.
You should only be able to insert 2 fingers between the
shoulder strap and waist strap.
NOTE: Winter/ Summer clothing can make a difference to the
size of your child.
8- Satisfactory shoulder strap position:
9- Crotch strap position adjustment:
Open the harness (refer to step 5,a).
Remove the crotch pad (b) and seat liner (c).
Lift the front of the seat cover away from the buckle (d).
Adjust the crotch strap position (e).
Push the buckle through seat cover slot.
Refit the seat cover, seat liner and crotch pad.
10-
Locate the three vehicle ISOFIX anchor points.
The two ISOFIX low anchorage anchor points are usually
located between the vehicle seat base and back (a).
Some vehicles have ISOFIX indicator near the ISOFIX low
anchorage anchor points (b).
11-
The ISOFIX top-tether strap anchor point is located at either
the top of the seat (saloon) (a), the rear of the seat (b), the
vehicle floor (c) or the vehicle ceiling (d). If in doubt, please
consult the vehicle handbook.
12- Fitting the ISOFIX guides (Optional):
The ISOFIX guides can help identify the vehicle ISOFIX anchor
points and make installation easier. They can also help with
the protection of your vehicle seat.
13-
Prior to fitting, unfasten the top-tether strap (a) and place at
the front of the child car seat (b).
Engaging the ISOFIX low anchorage points:
14-
Press and hold ISOFIX arm adjustment buttons (a) and
extended the arms fully (b).
15-
Engage the ISOFIX arms (a) and ensure that the ISOFIX arm
security indicators are green (b).
Push the child car seat back until its backrest is in firm contact
with the vehicle seat (c).
Attaching the top-tether strap:
16-
The top-tether strap may need to be lengthened to reach the
ISOFIX anchor point. To lengthen the top-tether strap squeeze
the release adjuster (a) and pull the strap out (b).