Overheat Protection; Overload Protection; Inserting/Changing The Batteries - Philips HP6581 Manual Del Usuario

overheat protection

This function helps to prevent overheating of the appliance.
Note: To avoid overheating of the appliance, do not press it too hard onto
your skin. The appliance works best when you move it over your skin without
excessive pressure.
If the overheat protection is activated, the appliance switches off
automatically and the charging light and the speed lights flash red for
30 seconds.
You can deactivate the overheat protection by letting the appliance cool
down and then switch it on again.
Note: If the charging light flashes red again, the appliance has not yet cooled
down completely.

overload protection

If you press the epilating head onto your skin too hard or when the
epilating discs of the epilating head get blocked (e.g. by clothes), the
appliance switches off automatically and the speed lights flash red for
5 seconds.
1 Turn the epilating discs with your thumb until you can remove
whatever blocks the epilating discs.
using the precision epilator

inserting/changing the batteries

1 Remove the lid of the battery compartment by pressing the snap
hooks.
2 Insert 2 AA 1.5V alkaline batteries into the battery compartment.
Note: Make sure the + and - poles of the batteries point in the direction
indicated at the bottom of the battery compartment.
Note: New batteries have an operating time of up to 40 minutes.
EnglisH
13