Publicidad
Idiomas disponibles
Idiomas disponibles
®
3.
With the help of a second installer to
support the first worksurface, gauge the
worksurface against each tether bracket,
and secure with #10 x 1" long pan head
screws. The Single Tether Bracket
should be located 2" from the edge of
the worksurface (locational pilot holes
provided).
4.
Secure the leg to the first worksurface
with #10 x 1" pan head screws. The long
edge of the worksurface is 1/16" proud of
the leg, and the end of the worksurface
is 1/32" proud of the leg (locational pilot
holes provided).
5.
Repeat steps 3 and 4 for the second
worksurface.
3
4
Page 3 of 16
100138 Rev A
Publicidad
