Foster OGNIDOVE Manual Del Usuario página 28

3) The left display shows alternatively a [ C ] and a [ 0 ]
4) Press the key lock until both displays indicate either [ C ] or [ - ].
5) Take your fingers away from the keys and press again the [ - ] key during a few seconds
until some [ E ] appear.
6) You will hear a "beep" sound and the [ E ] will blink.
7) The [ E ] are automatically transformed into [ C ] → The configuration has been
canceled.
VI) How to configure the hob ?
1) Use a suitable induction pot with a minimum diametre size of 16cm.
2) Select the heating zone by pushing the corresponding [ + ] key.
3) Put the pot on the corresponding heating zone.
4) Wait until [ C ] converts to [ - ]. The zone is configured
5) Use the same procedure for each other heating zone which displays [ C ]
6) The configuration is made if all zones are detected and if nothing is displayed
Use only 1 pot to configure the hob.
Never put two or more pots on the heating zones during the configuration.
•
If [ E 4 ] display persists call the After-sales Service
The hob or the cooking zone doesn't start-up
• The hob is badly connected on the electrical network.
• The protection fuse cut-off
• The locking function is activated
• The sensitive keys are covered of grease or water.
• An object is put on a key.
The symbol [ U ] displays
• There is no pan on the cooking zone.
• The pan is not compatible with induction.
• The bottom diameter of the pan is too small.
The symbol [ C ] or [ E ] displays
• Call the After-sales Service.
One or all cooking zones cut-off
• The safety system functioned
• You forgot to cut-off the cooking zone for a long time.
• One or more sensitive keys are covered.
• The pan is empty and its bottom overheated.
• The hob also has an automatic reduction of power level and breaking Automatic
overheating
Continuous ventilation after cutting-off the hob
• This is not a failure, the fan continuous to protect the electronic device.
• The fan cooling stops automatically.
28