Emmaljunga Viking Manual De Instrucciones página 60

Assembly and usage of seat unit
16
15
17
18
19
18
3
19
20
21
60
Attaching and releasing the seat-unit.
• Attaching the seat-unit: Engage the parking device: Lift the seat unit
and push the Easy Fix pieces (14) into the receivers on both sides
of the chassis (15) until it locks into position with an audible "click".
• The seat-unit can be attached in both driving directions.
WARNING
14
• Make sure that the seat-unit is correctly assembled on the chassis
before usage.
• To release the seat-unit: Start by engaging the parking device.
Press the handles upwards (16) on both sides at the same time and
then lift the seat-unit straight up.
WARNING
• Don't allow any child to be placed in the vehicle when it is being
16
folded/unfolded.
• Hold the handles steadily until the seat unit is in place.
IMPORTANT
• Make sure that the seat-unit is in place, before you start to use the
vehicle.
• Never lift the top part when it is assembled onto the chassis.
Adjusting the hood
• Adjust the hood by gently pulling the front backwards/forwards (17)
until it reaches the desired position.
IMPORTANT!
17
• Never lift the stroller by holding on to the hood.
• Never lift the top part when it is assembled on the chassis.
Note
• If the hood is moved up and down on the handlebar legs scratches
can occur on the paint. Keep the handlebar legs clean from dirt and
dust.
Sun Canopy
• The hood can be pulled forward to provide sun protection.
Adjusting the footrest
• The footrest can be adjusted into different positions. Adjust the
footrest to the down position by pushing in the release buttons (18)
on each side. Keep the release buttons pushed in and adjust (19)
into the desired position.
• To adjust into the horizontal position lift the footrest upwards.
• The stroller features an automatic adjustment of the footrest into
18
the horizontal position which is required for folding.
WARNING
• Do not let the child/children stand on the footrest.
Positioning of the shoulder straps
Moving from the lowest to the highest position.
21
• In order to move the shoulder straps to the highest position. Remove
the shoulder harness protection pads
20
• Open all the zippers to enable to access the backrest of the seat unit.
• Move the straps from the lower holes (20) to the higher position (21).
Moving from the highest to the lowest position.
• In order to move the shoulder straps from the highest to the lowest
22
position, follow the same steps as above.
Viking v. 3.0