Installing The Water Dispenser Line - Samsung RF23J9011SR/AA Manual Del Usuario

INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20 ~ 125 psi is required.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
• Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and a 6 mm (¼") compression nut.
• Use the new hose-sets supplied with the
appliance only. Do not re-use an old hose set.
Connecting to the water supply line
1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Cold water line
Pipe clamp
Shut off valve
DA68-03194D-00.indb 17
3. Connect the water line installation kit to the shut
off valve.
Cold water line
Pipe clamp
Shut off valve
Connecting the water supply line to the
refrigerator
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Using Copper Tubing
• ¼" copper tubing
• ¼" compression nut (1pc)
• Ferrule (2pc)
Compression Nut
(1/4") (Assembled)
Ferrule
(Not supplied)
Copper tubing
(Not supplied)
Household water supply line
English - 17
Water line installation
kit
Using Plastic Tubing
• ¼" plastic tubing
→ Molded end (Bulb)
• ¼" compression nut (1pc)
Refrigerator
Plastic Tubing
(Assembled)
Compression
Fitting
(Assembled)
Molded end
(Bulb)
Compression
nut (B) (1/4")
(Not supplied)
Plastic tubing (A)
or
(Not supplied)
14. 12. 18. 9:41