Mopar 82211870 Instrucciones De Montaje página 2

2
PROCEDURE STEPS:
FOG LAMP INSTALLATION
1. Install the fog lamps (1) by following the instructions
supplied with the replacement bumper kit.
NEW MULTI­FUNCTION SWITCH INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint
System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor,
or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) ca­
ble, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service.
This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Disconnect the negative battery cable.
2. Remove the three screws from lower shroud.
Remove both the upper (1) and lower (2) shrouds
from the steering column.
.
Oct 24, 2008 K6860678 Rev. 1