Descargar Imprimir esta página

Mopar 82211870 Instrucciones De Montaje página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Disconnect the instrument panel wire harness
connector from the connector receptacle on the back
of the left multi­function switch.
4. Remove the screw (2) that secures the left multi­func­
tion switch (1) to the mounting bracket integral to the
left side of the clockspring (3) on the steering column.
5. Slide the switch away from the clockspring far enough
to disengage the slide tabs on the switch housing from
the channel formations in the mounting bracket.
6. Disconnect the jumper wire harness connector from
the connector receptacle on the inboard end of the left
multi­function switch.
7. Remove the switch from the clockspring.
8. Position the new left multi­function switch (1) close
enough to the mounting bracket (3) integral to the left
side of the clockspring to reconnect the jumper wire
harness connector to the connector receptacle on the
inboard side of the switch housing.
9. Align the slide tabs on the switch housing with the channel formations integral to the clockspring mounting bracket,
then slide the switch into the bracket until it is firmly seated.
10. Install and tighten the screw (2) that secures the mounting tab on the front of the left multi­function switch to the
mounting bracket on the clockspring. Tighten the screw to 1 N∙m (10 in. lbs.).
11. Reconnect the instrument panel wire harness connector to the connector receptacle on the back of the switch hous­
ing.
12. Position both the upper (1) and lower (2) shrouds on
the steering column.
13. Install the three screws in the lower shroud (2).
Oct 24, 2008
3
K6860678 Rev. 1

Publicidad

loading