Mopar 82211870 Instrucciones De Montaje página 6

6
12. Position the TIPM onto the mounting bracket and push
down until the mounting clips are fully seated.
13. Position the TIPM positive cable (4) onto the mounting
stud and install the retaining nut (2). Tighten the nut
to 9 ­ 11 N∙m (80 ­ 100 in. lbs.).
14. Remove the grill by twisting the center of the six push pin fastener (1) inserts. This will allow the pin to release and
to be removed.
15. Using a trim stick C­4755 or equivalent, Release the lower clips (3) and separate the grille from the front end module.
16. Disconnect the electrical connectors (4).
Oct 24, 2008 K6860678 Rev. 1