Installing The Dust Bag; Assembling Dust Elbow And Dust Bag - Skil 3820 Instrucciones De Funcionamiento

SM 2610005400 10-09:SM 2610005400 10-09.qxp 12/2/09 7:55 AM Page 36

Installing the Dust Bag

1. Simply push the dust bag 1 completely onto the dust port 2
(Figure 5).
2. Position dust bag so that it does not interfere with the tool
during the cutting operation for all miter/bevel settings.
The dust bag requires emptying when full of sawdust. Empty it
frequently and after completion of sawing. Carefully remove
dust bag from dust port. Empty dust bag in proper trash bin by
unzipping the bag. zip the bag before installing on the dust
port. Be extremely careful of dust disposed, materials in fine
particle form may be explosive. Do not throw sawdust on an
open fire. Spontaneous combustion, may in time, result from
mixture of oil or water with dust particles.
The dust port 1 can also be attached to a standard 1-1/2"
vacuum tube for dust collection.
W RNING
any other materials that may contain carcinogens, use special
precautions. A suitable respirator must be worn by all
personnel entering the work area. Work area should be
sealed by plastic sheeting and persons not protected should
be kept out until work area is thoroughly cleaned.
Assembly
When sawing chemically pressure treated
lumber, paint that may be lead based, or
FIG. 5
1
36
2