Blade Square To Fence - Skil 3820 Instrucciones De Funcionamiento

SM 2610005400 10-09:SM 2610005400 10-09.qxp 12/2/09 7:55 AM Page 42
Adjustments

Blade Square to Fence

1. Lower the head assembly and push in the lock pin 1 to
lock in the lower position.
2. Make sure table is in 0° detent and tighten miter lock
knob.
3. Place a combination square 2 against the fence 3 and
next to the blade 4 as illustrated. Locate the square
properly so it does not contact the tooth of saw blade.
The saw blade should contact the full length of the
square (Figure 10).
4. If blade does not contact the square, follow the fence
alignment procedure.
Fence lignment
a. The head assembly should remain in lowered
position.
b Move sliding fence to proper position. (See Sliding
Fence on page 54.)
c. Using the supplied hex wrench, loosen the four (4)
hex cap screws 5 behind fence 6 (Figure 11).
d. Adjust fence until blade and the fence has full
contact with the square.
e. Tighten hex cap screws.
FIG. 10
1
3
FIG. 11
6
5
42
4
2
6
5