Miter Scale (Vernier) Indicator Adjustment; Laser Alignment System - Skil 3820 Instrucciones De Funcionamiento

SM 2610005400 10-09:SM 2610005400 10-09.qxp 12/2/09 7:55 AM Page 44
Adjustments
miter Scale (Vernier) Indicator
1. Raise the head assembly to the full-up position.
2. Loosen the miter lock knob 1 and move table 2 to either
side of the 0° miter mark on scale 3 (Figure 12).
3. Loosen the three (3) Phillips screws 4 & 5 that hold the
scale 3 in place.
4. Move table 2 back to the 0° miter mark on scale 3 and
tighten the miter lock knob 1.
5. Position the 0° miter mark on scale 3 so it's aligned with
the indicator line 6 on the table 2.
6. Carefully tighten the left and right screw 4 without moving
scale 3, then move table 2 to either side and tighten the
center screw 5.

laser Alignment System

Your miter saw is equipped with a laser alignment system to
help identify where the blade will contact the work piece. The
laser line has been adjusted to the center of the blade. You
should make a practice cut into a scrap piece of wood so you
know exactly where to place your workpiece.
The tool power cord must be plugged in, but you do not have
to activate the trigger to use the laser. The laser alignment
system can be turned on or off by using the switch 24 shown
on page 10.
Adjustment
FIG. 12
2
.
4
3
44
4
5
6
0
1