Fagor evo PRO 300 Manual Del Usuario página 16

1.5 Edit a channel
To change an input or output channel, place at that input channel list.
Once display the channel to edit, press the right arrow.
Change the input and output channel numbers and save again.
1.6 Delete a channel
To delete a channel, place at that input channel list.
The channel must be edited, and must be configured with input channel in number Ch00.
Once the channel is saved, this will be removed.
2. IN-FM Pre-Amp
This menu allows enabling or disabling the FM pre-amplifier provided by the module that acts to the FM
port signal.
3. IN-SAT LNB
In this menu, the satellite polarity of the SAT input signal will be selected.
The options are: DC Off (without selection), Vertical Low, Vertical High, Horizontal Low, Horizontal High
and By Pass (bypasses the DiSEqC signal from the output to the SAT input).
In case of selecting a polarity, it also allows to power the LNB (150 mA).
4. Output
In this menu it will be configured:
 VHF / UHF Amplifier output power: from 89 dBµV to 109 dBµV.
The output power is referred to channel power, and the more channels are added, the less output
power must be set for each channel.
 VHF / UHF Slope: from 0 and 9 dB.
 Satellite signal gain: from 25 to 45 dB.
5. Set Country
In this menu, the channel and frequency list used in the channel conversion will be selected.
6. Set Language
In this menu, the language used by the module to show the texts in the LCD screen will be selected.
7. FW Version
This menu will show the hardware, MCU and software versions working in the module.
8. Reset default
Allows loading in the module a default configuration, clearing permanently all the previous programming
of the module.
9. Lock
To avoid unauthorized people changing the settings or unintended handling, the module can be locked
with security code.
9.1 Set Pin Code. This option allows the user to change the pin code.
9.2 Lock. The pin code requirement will be enabled.
9.3 No Lock. The pin code requirement will be disabled.
10. LCD Timeout
By default, the display will turn off in 30 seconds if there's no user interaction.
This will be again switched on when the user press any key.
The timeout can be modify in 30, 60, 90 or 120 seconds.
Default pin code: 0000.
16