Initial Operation; Mounting Grip Rod; Mount Ejector Chute And Shift Linkage; Adjust The Ejector Chute - Grizzly Tools ASF 4046 L-Lion Traducción Del Manual De Instrucciones Original

Other devices from this product
range can be operated with the
same batteries.

Initial Operation

Only insert the rechargeable
battery when the device is com-
pletely assembled. Danger of
injury!
Ensure that the safety key (
is removed before all tasks.

Mounting grip rod

Mount central bar:
1. Place the central bar (7) on the
lower bar (10). If the assembly
is correct, the bore in the plastic
shroud (21) will be underneath
the pipe (see
2. Screw the central bar (7) with
the enclosed screws, butterfly
nuts and washers (12) right and
left on the lower bar (10). The
butterfly nuts point inwards.
Mount top grip bar:
3. Screw the top grip bar (1) with
the enclosed screws, butterfly
nuts and washers (6) right and
left on the central bar (7). The
butterfly nuts point inwards.
Clip in cable holder:
4. Clip the enclosed cable holder
(8) on the central bar (7) and
use it to secure the machine ca-
ble (20).
23)
).
Mount ejector chute and shift
linkage
Mount ejector chute:
1. Place the ejector chute (16) on
the machine housing (11) and
screw this with the 4 enclosed
cross-head screws (30).
Mount shift linkage
2. Push the top shift rod (5)
through the opening in the plas-
tic shroud (21) on the central
bar (7).
3. Release the fastening screw
(31) on the lower shift rod (9).
4. Push the top (5) and bottom
(9) shift rod together and screw
them with the fastening screw
(31).
5. Push the handle of the top shift
rod (5) in both directions. The
ejector chute (
able to move freely.

Adjust the ejector chute

The following settings are possible:
- Turning the ejector chute to the right
or left through a total of 190°;
- Tilting the ejector chute up or down
through 60°;
The steeper the ejector deflector (19),
the further the snow will be thrown.
1. Bring the ejector chute (16) into
the required direction by turning
the handle (5) of the shift link-
age.
2. Release the butterfly nuts (18)
on the ejector chute and fold the
ejector deflector (19) into the
required position.
GB
16) must be
25