Commissioning; Danger; Controls And Safety Features; Controls - JAC UNIC Manual Del Usuario

5.4

Commissioning:

Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
Ensure first of all (after verifying electrical compatibility) that the motor is rotating in the right direction.
Do this by pressing the start button and checking that the front box belt goes upwards.
If this is not the case, disconnect immediately and switch two phase wires in the plug.
For machine operation, please refer to the "Operation" chapter.
5.5

Danger:

If the user or the machine is in danger, you must use the main isolator switch to cut the power supply
to the machine.
Keep clear of the tray proofers when they are in motion.
Remove the plug from the power socket before any maintenance and/or servicing work.
Any maintenance work or replacement of parts must be carried out by an approved agent.
6

CONTROLS AND SAFETY FEATURES

6.1

Controls:

Your machine is equipped as standard with a mechanical control panel (fig.4, 5, 6).
6.2

Work area:

The work area is located in front of the machine outfeed belt (fig.3, n°16).
6.3

Safety features:

This machine is equipped with the following safety features:
- A lever switch (fig.14, n°26) if the safety chute (UNIC – TRADI) (fig.1, n°3) is pulled forwards or if
the safety bar is operated (FORMA) (fig.2, n°14).
- An encoded magnetic switch (fig.14, n°27) which prevents the machine from starting if the front
housing is open.
- An emergency stop button (fig.4, 5, 6, n°19).
Trigger action and mechanical latching emergency stop.
Compliant with EN/IEC 60204-1 and EN/ISO 13850:2006, Machinery Directive 98/37/CE and EN/IEC
60947-5-5.
English
10