Horizon Global 24999 Instrucciones De Montaje página 6

Remove underbody panel – Remove appearance panel which
covers the driver's side frame rail. Remove 10mm hex nuts and
plastic push fasteners (Fasteners are released by first pulling out
center post with small flat edge screwdriver).
Lower muffler & remove heat shield - Lower exhaust (2) rubber
isolator hangers, one on side and rear of muffler. Note: Spraying
a lubricant or soapy water on the metal hanger rod and the
rubber isolator helps removal.
©2021 Horizon Global™ Corp - Printed in Mexico
Remove underbody panel – Remove rubber plugs from the frame
rail, if present.
Lower muffler & remove heat shield - Remove heat shield using
10mm socket. Trim as shown. See figure 2.
Sheet 6 of 33 24999NP 1-08-21 Rev. A