Horizon Global 24999 Instrucciones De Montaje página 8

Remove fascia/bumper – Unplug electrical connector behind
fascia on driver side. Set fascia aside.
Trim lower fascia – Find and mark the center of the fascia on the
bottom. Trim lower fascia as shown. See figure 3. Recommend
radius in corners. Trim support ribs on inside of fascia in trim area
also.
2" [50.8]
4" [101.6]
Figure 3
©2021 Horizon Global™ Corp - Printed in Mexico
C L
2.5"
[63.5]
Remove fascia/bumper – Using Phillips screwdriver remove the
lower fascia bracket that connects the bumper to the fascia, one
each side.
Raise hitch for template - Using reverse pull wire procedure, install items 1 & 2
into existing access hole in frame(leave pull wire attached to item 1). Feed the
pull wire through the forward holes on the hitch. Raise hitch into place, feed
item 3 over pull wire, using the conical washer to hold the bolt in place remove
the pull wires and attach the hex nut. Hand tighten both sides. Check to
assure hitch is even and centered on vehicle. Using the hitch as a template
mark or center punch the (2) rearward holes on both sides.
Sheet 8 of 33 24999NP 1-08-21 Rev. A