Horizon Global 24999 Instrucciones De Montaje página 9

Drill holes – being careful, lower hitch making sure not to knock
forward bolts into frame rail. Re-attach pull wires and remove or
push current fastener out of way. Drill holes and remove any
burrs.
Re-install heat shield – Re-install trimmed heat shield.
©2021 Horizon Global™ Corp - Printed in Mexico
Install fasteners – Install the rear fasteners into drilled holes. Feed the coiled
end of the pull wire through the drilled hole in the frame rail and out the
access hole. Pull the pull wire with fasteners into location through the hole.
Leave pull wires attached. Repeat the same process on both frame rails. Re-
install or pull forward fastener into place. Leave pull wires attached.
Install hitch – Raise hitch into position, feed pull wire through
corresponding holes on hitch. Using the conical washer to hold
the bolt in place remove the pull wires and attach the hex nut.
Tighten to hold hitch in place, repeat on all fasteners. Check to
assure hitch is even and centered on vehicle.
Sheet 9 of 33 24999NP 1-08-21 Rev. A