Satelec PIEZOTOME Manual De Uso página 13

3) Contact the SATELEC After-Sales Service (see
Section 10.2).
4. 3 INSTALLATION
It is important to follow the instructions below in
order.
a) Unit connections
1) Position the Unit (Figure 1, #A) in easy reach
on a flat surface which is tilted to an angle of
no more than 10°.
2) Insert the two rods of the bracket (Figure 3,
#2) into the bracket supports (Figure 3, #1) so
that the bracket is suspended above the Unit.
3) Plug the multifunction footswitch cord
connector (Figure 5, #6) into the Unit (Figure
3, #7).
4) Place the footswitch on the ground so it is
easy to operate with the foot.
5) Plug the mains cord (Figure 1, #B) into the
power supply socket (Figure 3, #4).
6) Plug the P
IEZOTOME
(Figure 1, #J) into one of the unit cord
connector (Figure 2, #3 or #4), taking care to
align the red marks on each of the two
components.
7) If the N
EWTRON
N cord (Figure 1, #O) into the
EWTRON
unoccupied cord connector (Figure 2, #3 or
#4).
8) Connect the N
EWTRON
to its cord (Figure 1, #O).
Refer to the User's manual delivered with
the equipment.
Nota:
• In the same way, it is possible to connect a
second P handpiece and its cord (Figure
IEZOTOME
1, #J) or a second N
unoccupied cord connector.
handpice and its cord
function is chosen, plug the
handpiece (Figure 1, #N)
cord to the
EWTRON
• When it is switched on, the device
automatically identifies which type of cord is
connected (P
IEZOTOME
5.2.c).
b) Fitting the tip to the handpiece
1) Screw a tip (Figure 1, #K) into the handpiece
(Figure 1, #J ou #N) using the wrench (Figure
1, #L).
Refer to the User's manual delivered with
the equipment.
2) Lay the handpiece on its support (Figure 1,
#D).
NB: A handpiece compatibility system makes it
impossible to screw a P
Surgery, Sinus Lift or ligament cutting) to a
N handpiece or a CCS tip (periodontics,
EWTRON
endodontics, etc.) to a P
c) Installing the irrigation line
The following instructions describe how to install
an irrigation line. You will have to repeat the
process to install a second irrigation line.
1) Open the sterile pouch and remove the
irrigation line.
2) Connect the end of the silicone tube to the
end of the cord connector.
3) Lift the pump cover on the same side of the
device (Figure 4, #1).
4) Introduce the pump cartridge (Figure 4, #3)
into its special compartment (Figure 4, #2).
5) Close the pump cover (Figure 4, #1), taking
care not to trap any of the tubes.
6) Push the pump cartridge pin into the cap of
the irrigation solution bottle/bag and open
the air vent (if there is one).
7) If there is only one bottle/bag: hang the hook
from the frame's central attachment point
(Figure 1, #F-a).
13
or N ) (see Section
EWTRON
surgery tip (Bone
IEZOTOME
handpiece.
IEZOTOME