Changing The Fuses; Fan; Inspection; Maintenance - Satelec PIEZOTOME Manual De Uso

11) Put the mains cord back into its socket (Figure
3, #4).

6. 4 CHANGING THE FUSES

1) Set the power supply switch (Figure 3, #6) to
"O".
2) Pull the mains cord out of its socket (Figure 3,
#4).
3) Introduce the point of a flat screwdriver into
the notch above the fuse drawer to release it
(Figure 3, #3).
4) Remove old fuses.
5) Replace with new fuses of the same type and
rating.
6) Push the fuse drawer back into its
compartment until a click is heard to indicate
that it is in the correct position.
7) Put the mains cord back into its socket (Figure
3, #4).
NB: the device also contains two internal fuses
which the user cannot access. Contact the
SATELEC After-Sales Service (see Section 10.2).

6. 5 FAN

Regularly check the fan for dust.
Proceed as follows:
1) Set the power supply switch (Figure 3, #6) to
"O".
2) Pull the mains cord out of its socket (Figure 3,
#4).
3) Clean off the fan by gently blowing through
the air vents (Figure 3, #5).
4) Put the mains cord back into its socket (Figure
3, #4).

6. 6 INSPECTION

The accessories and cords should be regularly
checked for faulty insulation. Replace, if
necessary.
If any problem is observed, you are recommended
to contact the SATELEC After-Sales Service (see
Section 10.2) rather than some other repair
service.
VII - MAINTENANCE

7. 1 TROUBLESHOOTING

NB: the user should never attempt to repair or
modify the device without prior permission from
SATELEC.
19