Skil 2356 Instrucciones De Funcionamiento Y Seguridad página 21

SM 1619X07542 08-12_SM 1619X07542 08-12.qxp 8/27
When the indicator light turns "OFF" fast
charging is complete.
If the green charging indicator light turns red
during use, this indicates the battery needs to
be charged.
After normal usage, the battery requires
approximately 3 to 5 hours charging time to
reach full capacity. The tool may be used even
though the light may still be on. The light may
require more than 3 hours to turn off depending
on temperature.
The purpose of the light is to indicate that the
battery is fast-charging. It does not indicate the
exact point of full charge. The light will turn off
in less than 3 hours if the battery was not
completely discharged.
When the battery is fully charged, unplug the
charger (unless you're charging another tool).
Push Sliding Switch to rear position to
illuminate Bit Window. (Note: if already in rear
position, squeeze trigger to illuminate Bit
Window). Rotate Bit Magazine until desired bit
is shown in Bit Window.
Push Sliding Switch forward to position bit into
Magnetic Bit Holder for use.
WARNING
The second bit may eject forcefully when the
SELECTING BITS
REPLACING BITS
Do not insert two bits into a
single Bit Magazine slot.
21