Machine Data; Safety Instructions - Ferm ATM1036 Manual Del Usuario

EN
Air tool sEt 5 pcs.
contents:

1. Machine data

2. Safety instructions

3. Use
Read the safety and operating
instructions of the air tool set and the
compressor before using the appliance!
1. Machine data
Spray gun
Operating pressure
Nozzle diameter
Aluminium cup capacity
Weight
Tyre inflating gun with pressure gauge
Operating pressure
Length of hose
Weight
Air blow gun
Recommended pressure
Nozzle diameter
Weight
Air engine cleaning gun
Recommended pressure
Nozzle diameter
Aluminium nozzle length
Weight
5m pu hose
Type
Max. pressure
Coupler
Weight
2. Safety instructions
Always read the user manual of the
compressor and of the objects and/or
materials you use.
• Avoid too high pressure
• Never blow or spray in direction of yourself or
others; this could cause serious injury.
• Keep bystanders and pets away
• Children and animals should be kept far away
from the area of operation of the machine.
• If you use the compressor to spray paint:
2
a) Do not work in enclosed spaces or near naked
flames.
b) Make sure that the environment in which you
will be working has dedicated ventilation.
c) Protect your nose and mouth with a dedicated
mask
• If the compressor is no longer in use, always
take the plug out of the plug socket.
• Always make sure that compressed-air hoses
are used for compressed air and which are
characterised by a maximum pressure
adjusted to that of the compressor. Do not try
to repair the hose if it is damaged.
4.5 - 6 bar
3. Use
1.5 mm
400 cc
Only use the compressor with accessory in a good
0.55 kg
ventilated area.
• Connect the PU hose between compressor
and accessory
0 - 8 bar
• Slide the hose-coupler on the accessory until
350 mm
the coupler clicks. Now the hose is connected
0.40 kg
correctly.
• To release the coupler, pull the outside ring
backwards.
2 - 4 bar
2.0 mm
Spray gun
0.15 kg
Paint and solvents are very flammable. Therefore
check the following:
• Only spray in good ventilated areas
2 - 4 bar • Use a spray-mask during spraying
2.0 mm
• Avoid open fire and smoking during spraying
255 mm
• Do not spray in an area with a burning stove
0.55 kg
• Never spray with fuel of other flammable
products
• Wear safety goggles
5 mm x 8 mm
8 bar
To obtain the best results, it is important that you
Universal/DIN
prepare the surface to be sprayed and thin the
0.25 kg
paint to the correct viscosity, before you operate
your spray gun. Always ensure that the surfaces to
be sprayed are free from dust, dirt and grease.
Make sure that you have masked the areas that
should not be sprayed, using a good quality
masking tape. The paint or fluid to be sprayed
should be thoroughly mixed and free from lumps
or other particles. Many substances can be
sprayed with your spray gun, but always check the
manufacturers recommendations before
purchasing your paint.
To obtain the best results, keep your spray gun
level and parallel to the surface at all times.
Keep the nozzle 25 - 30 cm from the surface and
Ferm