Tabla de contenido
Publicidad
AIR TOOL SET FAT-850
CONTENTS:
1. Machine data
2. Safety instructions
3. Use
READ THE SAFETY AND OPERATING
INSTRUCTIONS OF THE AIR TOOL SET
AND THE COMPRESSOR BEFORE
USING THE APPLIANCE!
1. MACHINE DATA
SPRAY GUN
Operating pressure
4.5 - 6 bar
Nozzle diameter
1.5 mm
Aluminium cup capacity
400 cc
Weight
0.55 kg
TYRE INFLATING GUN WITH PRESSURE
GAUGE
Operating pressure
0 - 8 bar
Length of hose
350 mm
Weight
0.40 kg
AIR BLOW GUN
Recommended pressure
2 - 4 bar
Nozzle diameter
2.0 mm
Weight
0.15 kg
AIR ENGINE CLEANING GUN
Recommended pressure
2 - 4 bar
Nozzle diameter
2.0 mm
Aluminium nozzle length
255 mm
Weight
0.55 kg
5M PU HOSE
Type
5 mm x 8 mm
Coupler
Universal/DIN
Weight
0.25 kg
2. SAFETY INSTRUCTIONS
Always read the user manual of the compressor
and of the objects and/or materials you use.
•
Avoid too high pressure
•
Never blow or spray in direction of yourself or
others; this could cause serious injury.
•
Keep bystanders and pets away
•
Children and animals should be kept far away from
the area of operation of the machine.
•
If you use the compressor to spray paint:
a) Do not work in enclosed spaces or near naked flames.
b) Make sure that the environment in which you will be
working has dedicated ventilation.
c) Protect your nose and mouth with a dedicated mask
2
•
If the compressor is no longer in use, always take the
plug out of the plug socket.
•
Always make sure that compressed-air hoses are
used for compressed air and which are characterised
by a maximum pressure adjusted to that of the
compressor. Do not try to repair the hose if it is
damaged.
3. USE
Only use the compressor with accessory in a good
ventilated area.
•
Connect the PU hose between compressor and
accessory
•
Slide the hose-coupler on the accessory until the
coupler clicks. Now the hose is connected correctly.
•
To release the coupler, pull the outside ring
backwards.
SPRAY GUN
Paint and solvents are very flammable. Therefore check
the following:
•
Only spray in good ventilated areas
•
Use a spray-mask during spraying
•
Avoid open fire and smoking during spraying
•
Do not spray in an area with a burning stove
•
Never spray with fuel of other flammable products
•
Wear safety goggles
To obtain the best results, it is important that you
prepare the surface to be sprayed and thin the paint to
the correct viscosity, before you operate your spray
gun. Always ensure that the surfaces to be sprayed are
free from dust, dirt and grease. Make sure that you have
masked the areas that should not be sprayed, using a
good quality masking tape. The paint or fluid to be
sprayed should be thoroughly mixed and free from
lumps or other particles. Many substances can be
sprayed with your spray gun, but always check the
manufacturers recommendations before purchasing
your paint.
To obtain the best results, keep your spray gun level and
parallel to the surface at all times.
Keep the nozzle 25 - 30 cm from the surface and spray
evenly from side to side or up and down. Do not spray at
an angle as this will lead to paint runs on the surface. Use
smooth and even strokes.
It is essential that the spray gun is cleaned thoroughly
after every use. Failure to clean it will almost certainly
result in blockages and it may not operate when you next
come to use it! The guarantee does not cover cleaning a
sprayer that has not been properly cleaned by the user.
Ferm
Ferm
39
Publicidad
Tabla de contenido
