Ryobi EBS-8021V Manual De Utilización página 12

GB
F D
SPECIFICATIONS
Input
Power
No load speed
Belt size
Net weight
Be sure to check the nameplate on the product,
because the voltage is subject to change depending
on the area in which the product is to be used.
DESCRIPTION
1. Adjustable front handle
2. Sanding belt
3. Tension release lever
4. Rear handle
5. Dust bag
6. Dust port
7. Lock-on button
8. Switch
9. Adjustment screw
10. Front roller
11. Rear roller
12. Variable speed control
13. Livetool IndicatorTM
14. Front handle release button
15. Slot holder
STANDARD ACCESSORIES
Dust bag, Abrasive belt.
OPTIONAL ACCESSORIES
G-Clamp, Sanding frame.
APPLICATIONS
Use only for the purpose listed below:
1. Surface finishing for wood.
2. For removal of rusl and surface finishing for metal.
NOISE BUILD-UP
Noise (sound pressure level) in the workplace can exceed
85 dB(A). In this case, sound insulation and hearing
protection measure must be taken by the operator.
E I P NL
230 V~50 Hz
800 W
150-300 m/min
76 x 533 mm
3.6 kg
S DK N FIN GR
English
SWITCH (FIG. 1)
This tool is started and stopped by squeezing and
releasing the trigger (8).
For continous operation, press the lock-on button (7)
while trigger is being squeezed. Squeeze trigger again to
release the lock.
The belt speed can be freely adjusted from 150 to 300
m/min by turning the variable speed control (12).
(1= lowest speed / 6 = highest speed )
DUST BAG (FIG. 2)
When sanding wood, the dust bag (5) should be used.
Although the dust bag has a substantial capacity,
it should be emptied frequently.
Opening the zipper of the dust bag allows complete
cleaning.
CHANGING THE ABRASIVE BELT (FIG. 3 TO 4)
Place the tool on its side and lift the lever (3)
■
to retract the front roller and release the belt tension
(Fig. 3).
Pull the sanding belt off.
■
Mount a new sanding belt.
■
NOTE! Be sure that the arrow inside of the belt is
pointing in the same direction as that of the tool.
Push the lever down to the original position (Fig. 4).
■
ADJUSTABLE FRONT HANDLE (FIG. 5)
FRONT HANDLE RELEASE BUTTON
Press the front handle release button (14) to allow the
front handle to be adjusted to the desired working
position.
8
RO
H CZ RUS
CAUTION!
When sanding metal, the dust bag should not be
used, because of the risk of fire from flying sparks.
WARNING!
BE SURE TO DISCONNECT THE TOOL FROM
THE POWER SUPPLY WHEN MOUNTING AND
REMOVING THE SANDING BELT.
CAUTION!
Ensure that your fingers are not trapped.
HR
PL SLO TR